PX4 Black Compensator

Compensator for Marui's gas handgun, BERETTA PX4.

■Product Overview
A rare custom part for the PX4.
The design is based on a real firearm compensator with added rails.
Confirmed to fit Marui's PX4 and compatible models.
The design follows the subtle angle of the slide.

■Installation Method
Securely tighten the pre-installed set screw with a hex wrench.
A separate stopper part inside is designed to prevent damage to the .
If the stopper is difficult to lower even after loosening the screw, try sliding it back and forth gently, or lightly tap it onto a surface like rubber to lower the stopper.

■Notes
The is not included in the sale.
This is a personally produced item made with a 3D printer, so there may be visible layer lines and some roughness.
While there have been no complaints about previous sales, please do not have excessive expectations.
We use carbon fiber PLA, a material with less gloss that is stronger and heavier than ABS. However, please be aware that extreme force or temperatures above 60°C may cause breakage or deformation.

#Other original custom parts here