BetaFPV F3 Drone with Integrated VTX and Red & Black Propellers

A quadcopter drone with red and black propellers and a camera.

- FC: BETAFPV F3 with OSD chip
- Propeller color: Red and black
- Number of propellers: 4
- With camera: Yes, without OSD
- Frame color: White
- Frame shape: Quadcopter

Thank you for looking.

This drone has been reconfigured using the frame and motors from a Holystone toy drone.
The motor wiring has been soldered.
The battery compartment has been cut to accommodate various battery sizes since I acquired it.
The flight controller is an F3 chip, which is old but a new part.
The shaft diameter is 0.8mm.
A new integrated camera and VTX unit is used, but it does not have OSD functionality.
Channel B1:5733 seems to receive clearly.
The protocol is frskyD8, the same as Cetus... I believe.
A transmitter is not included, so I recommend the BetaFPV LITERADIO. It's cheaper than others.
Batteries up to 380mA are recommended for a nimble flight.
The flight controller (FC) firmware is 4.0.5, and BetaflightConfigurator is 10.6. An older environment and InpulseRC_Driver_Fixer are required.

Here is a web page with details about the FC:
https://betafpv.com/products/f3-brushed-flight-controller-frsky-rx-osd?srsltid=AfmBOopaUfXFhi66Q0KIjTLBFfVyFFMqIkhxT4wyGFUk9WG7SpKAQpER

Operation was confirmed from BIND to arming, hovering, indoor gentle flight, and landing.
It flew without issues, but there are some parts that could not be checked due to the configuration.

Please check the images and bid only if you are satisfied.