For Bar-sama: 2-piece 1/4 screw adapter set for Bonbonero

This is the purchase page for a set of two 1/4 screw adapters for Bonbonero, exclusively for Bal-sama.

Below is the original product description.

Thank you for viewing.

This is an adapter for decorating Bonbonero on ZEROPOD38 etc.
Insert the longer fin on the bottom of the Bonbonero into the groove of the adapter and tighten the string to secure it.
*Images 4-7 show installation examples.

*Please be sure to use the ring part included with Bonbonero together.
*Cannot be used with versions where all fins are short, such as BONBONERO meets zero_cap.
*A Hakuba Camera Screw Adapter H-SA8 is attached to the bottom of the adapter.
*If you remove the adapter, it will be a 3/8 screw hole, but we do not recommend using it in that state due to strength concerns.
*We do not plan to produce M8 as the hole is large and difficult to shorten.
*This product is 3D printed and handmade, so there may be slight individual differences.
*We cannot be held responsible for any damage or malfunction of Bonbonero or connected products such as ZERO TORCHSTAND due to the use of this product.
*Specifications and prices are subject to change in the future.

*If you wish to change the color of the product, please check your profile.
*If you wish to purchase multiple items, please contact us in the comment section.

Search
#ボンボネロ
#bonbonero